Посібник Panasonic ES-8161 Бритва

Посібник

7

Before use

This Wet/Dry shaver can be used for

wet shaving with shaving lather or for

dry shaving. You can use this water-

tight shaver in the shower and clean

it in water. Treat yourself to wet lather

shaves for at least three weeks and

notice the difference. Your Panasonic

Wet/Dry shaver requires a little time

to get used to because your skin and

beard need about a month to adjust

to any new shaving method.

Parts identification

(see fig. 1)

A Protective cap

B System outer foil

C Inner blades

D System outer foil release buttons

E Pivot action selector

F LCD display [ES8163]

LED display [ES8162]

[ES8161]

G Battery capacity monitor

H Charge status lamp

I Low battery indicator

J On/Off switch

K Finger rest

L Trimmer

M Trimmer handle

N Adaptor

O Power cord

P Charging stand

Q Cleaning brush

R Soft case

READ ALL INSTRUCTIONS BE-

FORE USE.

Charging

Connect the power cord to the

shaver, and plug the adaptor to an

AC outlet. (see fig. 1 (A))

The shaver will be adjusted automati-

cally to voltages between 100-240V

AC.

In some areas, a special plug adap-

tor may be required.

• When charging the shaver for the

first time or when it has not been in

use for more than 6 months, the

plug symbol and backlight of LCD

display (ES8163) or charge status

lamp (ES8162, ES8161) may not

illuminate for a few minutes after

operation. These lights will eventu-

ally illuminate if kept connected.

Adequate ambient temperature for

charging is between 15 to 35 °C.

• If it is far below or over the appro-

priate temperature, the charging

time may extend, or the adaptor

may not function.

• In particular, low temperature may

shorten the life span of the re-

chargeable battery, In this case, the

backlight of LCD display (ES8163)

or charge status lamp (ES8162,

ES8161) blinks twice in 1 second.

[for ES8163]

When the shaver is being charged,

the backlight of LCD display turns

on, and the plug symbol appears

(see fig. 2 (A)).

8

It shows the remaining battery ca-

pacity from 0% to 100%, in 10% in-

crements.

When the charging is completed, it

will indicate “100%” and the backlight

of LCD display will flash once in

about 1 second. It will flash once in

about 2 seconds for 10 minutes af-

ter charging is completed (see fig. 2

(B)).

You can fully charge the shaver in 1

hour if the LCD display shows 10%

and lower.

The plug symbol blinks in the LCD

display when the remaining battery

capacity is 10% and less.

The unit can be used once or twice

more after the LCD display starts to

show 10%. (Differs depending on the

use situation.)

[for ES8162]

The charge status lamp will glow

when the shaver is being charged.

100 to 20 of the battery capacity

monitor will all illuminate and the

charge status lamp will blink after

charging is completed (see fig. 2 (C)).

10 minutes after charging is com-

pleted, the battery capacity monitor

will extinguish and the charge status

lamp will continue to blink (see fig. 2

(D)).

You can fully charge the shaver in 1

hour if the LED display shows 20%.

The battery capacity monitor indi-

cates the charge remaining in the

battery. The unit can be used once

or twice more after the “20” starts to

blink. (Differs depending on the use

situation.)

[for ES8161]

The charge status lamp will glow

when the shaver is being charged. It

will blink when the charging is com-

pleted (see fig. 2 (F)).

You can fully charge the shaver in 1

hour if the low battery indicator blinks

(see fig. 2 (E)).

The unit can be used once or twice

more after the low battery indicator

starts to blink.

A full charge will supply enough

power for approx. 14 shaves (3 min-

utes per shave for a normal beard).

Before travelling, charge it fully for 1

hour if you will not be taking the adap-

tor with you.

In case your shaver is without charge,

you may quick charge it for 1 shave

in about 5 minutes.

Charge with charging

stand

(see fig. 1 (B))

To charge with the charging stand,

connect the power cord to the charg-

ing stand. Place the shaver into the

stand, and plug the adaptor to the

AC outlet.

You can always store your shaver in

the charging stand to maintain full

battery capacity. This shaver cannot

be overcharged.

76

 P006-041̲ES8163̲62̲61̲EU  05.2.21 11:17  ページ6

Рейтинг

Детальніше про цей посібник

Ми розуміємо, що добре мати паперовий посібник для вашого Panasonic ES-8161 Бритва. Ви завжди можете завантажити посібник з нашого сайту та роздрукувати самостійно. Якщо ви бажаєте отримати оригінальний посібник, радимо зв’язатися з Panasonic. Вони можуть надати оригінальний посібник. Шукаєте інструкцію до свого Panasonic ES-8161 Бритва іншою мовою? Виберіть потрібну мову на нашій домашній сторінці та знайдіть номер моделі, щоб дізнатися, чи є вона у нас.

Технічні характеристики

Усі посібники для Panasonic Бритви
Більше посібників для Бритви

Часті запитання про Panasonic ES-8161 Бритва

Наша служба підтримки шукає корисну інформацію про товар і відповідає на поширені запитання. Якщо ви знайдете неточність у наших запитаннях та відповідях, повідомте нас про це, скориставшись контактною формою.

Супутні товари

Посібник

Panasonic ES-8168 Бритва

Посібник

Panasonic ES-8807 Бритва

Посібник

Panasonic ES-8103 Бритва

Посібник

Panasonic ES-8078 Бритва

Посібник

Panasonic ES-6003E8 Бритва

Посібник

Panasonic ES-8044 Бритва

Посібник

Panasonic ES-8043 Бритва

Посібник

Panasonic ES-8101 Бритва

Пов'язані категорії