IM011
www.scarlett.ru SC-058
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
Please read all the instruction manual before use and
save it for future references.
Before first switching on check that the voltage indicated
on the rating label corresponds with the mains voltage in
your home.
For home use only. Do not use for industrial purposes.
Use the appliance only for its intended use.
Do not use outdoors or in damp area.
To prevent risk of electric shock and fire, do not immerse
the appliance in water or any other liquids. If it has
happened DO NOT TOUCH the appliance, unplug it
immediately and check in a service center.
Do not use the appliance in immediate proximity to а
bath, а shower or а swimming pool.
Never pull the cord while disconnecting from the power
outlet; instead, grasp the plug only and pull to disconnect.
Do not allow the cord to touch sharp edges and hot
surfaces.
Always unplug the appliance from the power supply when
not in use.
If the power cord is damaged it should be replaced by the
manufacturer or authorized servicing center or qualified
professional for safety reasons.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliances by a person responsible
for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Do not leave appliance unattended while operating.
The appliance must be used only in the upright position.
Unit surface temperature of the appliance is high, thus do
not touch it, except the handle.
To avoid a circuit overload, do not operate another high
wattage appliance on the same circuit.
The heater is filled with a certain quantity of special oil.
Any maintenance that requires opening of the oil tank
may be performed only by the manufacturer or its
authorized service center that should repair the appliance
in case of oil leakage.
It is necessary to follow the instructions concerning used
oil utilization.
If the product has been exposed to temperatures below
0ºC for some time it should be kept at room temperature
for at least 2 hours before turning it on.
The manufacturer reserves the right to introduce minor
changes into the product design without prior notice,
unless such changes influence significantly the product
safety, performance, and functions.
CAUTION: Do not cover the appliance when in
WHEELS MOUNTING (FIG. A)
First turn the unit upside-down.
Install multidirectional rolling wheels to each end between
the first and the second groups of the heating flanges.
Let the “U” shape screw surround the dome of the heating
flanges. Then insert it into two holes of the supporting
plate.
Use butterfly nuts to screw them tightly counterclockwise.
Brackets and nuts are supplied with the appliance.
Place heater normally and make sure that it is
inconvertible.
USING THE APPLIANCE
Set the power switches to “0” position, and set the
temperature switch to “MIN” position.
Plug the device into the socket.
USING THE APPLIANCE
Set thermostat to minimal position and power switch to “0”
position, plug in the appliance.
POWER SELECTOR
You can adjust oil heater current power using power
regulator:
– “0” – Off;
– “I“ – Minimum power;
– “II” – Medium power;
– “III” – Maximum power.
THERMOSTAT
Set thermostat to maximum position.
When the temperature rises to satisfying level, slowly turn
the thermostat counterclockwise and the room
temperature thus can keep constant.
If you want to change the room temperature, you can
make another regulation: turn the thermostat clockwise to
arise the temperature and counterclockwise to lower it.
TIMER OPERATION
The ⊙/I (ON/OFF) switch is used to switch the timer on
and off. It is located on the inner timer disc. To set the
timer off time, set the outer timer disc to any position
within the range of 0 to 24 hours with 15 min increment.
NOTES:
The room must be properly sealed, if not, using of oil
heater will not make good result because of heat
leakage.
After you are finished using the radiator, set the power
switches to “0” position, and set the temperature switch to
position, and then unplug the radiator from the socket.
CLEAN AND CARE
The oil heater should be cleaned regularly to wipe out the
dust on the surface of fins. As this may result the radiating
efficient.
Unplug from the power supply and allow the appliance to
cool down.
Wipe out with a soft damp cloth. Do not use detergent or
abrasives.
Do not scrap the surfaces of fins with sharp hard tools, to
avoid surfaces getting rusty, because of damage of the
paint coat.
STORAGE
Switch off and unplug the appliance. Ensure the oil heater
is completely cool.
Complete all requirements of chapter CLEAN AND
CARE.
Reel on the power cord.
Keep the appliance in a dry cool place.
RUS РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ
МЕРЫ БЕЗОПАСНОСТИ
Внимательно прочитайте данную инструкцию перед
эксплуатацией прибора во избежание поломок при
использовании. Неправильное обращение может
привести к поломке изделия, нанести материальный
ущерб или причинить вред здоровью пользователя.
Перед первоначальным включением проверьте,
соответствуют ли технические характеристики,
указанные на изделии параметрам электросети.
Использовать только в бытовых целях. Прибор не
предназначен для промышленного применения.
Не использовать вне помещений или в условиях
повышенной влажности.
Во избежание поражения электрическим током и
возгорания, не погружайте прибор или шнур питания в
воду или другие жидкости. Если это произошло, НЕ
БЕРИТЕСЬ за изделие, немедленно отключите его от
электросети и обратитесь в Сервисный центр для
проверки.
Не использовать устройство в непосредственной
близости от ванны, душа или плавательного
бассейна.
Приєднуйтесь до розмови про цей продукт
Тут ви можете поділитися своєю думкою про Scarlett SC-058 Підігрівач. Якщо у вас є питання, спочатку уважно прочитайте інструкцію. Запит на інструкцію можна зробити за допомогою нашої контактної форми.