Посібник Scarlett SC-2151 Підігрівач

Посібник

IM011

www.scarlett.ru SC-2150/SC-2151/SC-2152

4

GB INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS

• Please read this instruction manual carefully before use and keep in a safe place for future reference.

• Before the first connecting of the appliance check that voltage indicated on the rating label corresponds to the mains

voltage in your home.

• For home use only. Do not use for industrial purposes. Do not use the appliance for any other purposes than

described in this instruction manual.

• Do not use outdoors.

• Always unplug the appliance from the power supply before cleaning and when not in use.

• To prevent risk of electric shock and fire, do not immerse the appliance in water or in any other liquids. If it was

happened DO NOT TOUCH the appliance, unplug it immediately and check in service center.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning

use of the appliances by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• Do not use other attachments than those supplied.

• If the power cord is damaged it should be replaced by the manufacturer or authorized servicing center or qualified

professional for safety reasons.

• Do not attempt to repair, adjust or replace parts in the appliance. Check and repair the malfunctioning appliance in the

nearest service center only.

• Keep the cord away from sharp edges and hot surfaces.

• Do not pull, twist, or wrap the power cord around appliance.

• Unit surface temperature of the appliance is high, thus do not touch it, except the handle.

• Operating unit should be far away from the flammable or easy bulging under high temperature objects. The convector

must not be located immediately below a socket-outlet.

CAUTION:

• Do not cover the appliance when it is in use.

• To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.

• If the product has been exposed to temperatures below 0ºC for some time it should be kept at room temperature for at

least 2 hours before turning it on.

• The manufacturer reserves the right to introduce minor changes into the product design without prior notice, unless

such changes influence significantly the product safety, performance, and functions.

INSTALLATION ON THE FLOOR

• Turn on the convector, attach the wheels to the bottom of the convector, make sure that the bolt holes are properly

aligned, then tighten the screws (supplied).

• Place the convector on the floor.

MOUNTING TO THE WALL

• Attach the large bracket to the wall, using the available bolts and nuts (supplied).

• Place the heater, leaving the distance between the base device and the floor for at least 50 cm, and make sure that

the distance between the upholstery and curtains is at least 1 m. Attach the rubber stops to the back of the device.

Place a large staple to the rear of the notches on the side of the device. Wear protective top small brackets and screw

them to the larger ones. It is necessary to secure the convector on the wall.

SWITCHING ON THE DEVICE

• Plug it into a suitable outlet, set the temperature controller at the highest level (i.e., turn the knob clockwise until it

stops), «High» position.

TEMPERATURE CONTROL

• When using this device you feel that the room temperature is too high, you can reduce it as follows: turn the

temperature controller anti-clockwise from the maximum position. After that, electric convector would work

intermittently.

POWER ADJUSTMENT

• The power regulator is used to set heating power. The convector has 3 power levels.

"ANTIFREEZE" MODE SETTING

• Set the power regulator to "1" position, and set temperature regulator to «Low» position. After that, the convector will

switch on automatically when room temperature drops to 5

о

С and will maintain temperature at this level.

TURNING OFF THE DEVICE

• To turn the device off, put a power regulator to 0 or disconnect the power cord.

WARNING:

• To avoid heat loss room should be kept closed, otherwise it will not get warm.

CLEAN AND CARE

• The convector should be cleaned regularly to wipe out the dust on the surface. As this may result the convection

efficient.

• Unplug from the power supply and allow the appliance to cool down.

• Wipe out with a soft damp cloth. Do not use detergent or abrasives.

• Do not scrap the surfaces of fins with sharp hard tools, to avoid surfaces getting rusty, because of damage of the paint

coat.

Рейтинг

Детальніше про цей посібник

Ми розуміємо, що добре мати паперовий посібник для вашого Scarlett SC-2151 Підігрівач. Ви завжди можете завантажити посібник з нашого сайту та роздрукувати самостійно. Якщо ви бажаєте отримати оригінальний посібник, радимо зв’язатися з Scarlett. Вони можуть надати оригінальний посібник. Шукаєте інструкцію до свого Scarlett SC-2151 Підігрівач іншою мовою? Виберіть потрібну мову на нашій домашній сторінці та знайдіть номер моделі, щоб дізнатися, чи є вона у нас.

Технічні характеристики

Усі посібники для Scarlett Підігрівачі
Більше посібників для Підігрівачі

Часті запитання про Scarlett SC-2151 Підігрівач

Наша служба підтримки шукає корисну інформацію про товар і відповідає на поширені запитання. Якщо ви знайдете неточність у наших запитаннях та відповідях, повідомте нас про це, скориставшись контактною формою.

Супутні товари

Посібник

Scarlett SC-250 Підігрівач

Посібник

Scarlett SC-057 Підігрівач

Посібник

Scarlett SC-153 Підігрівач

Посібник

Scarlett SC-058 Підігрівач

Посібник

Scarlett SC-1169 Підігрівач

Посібник

Scarlett SC-FH53K02 Підігрівач

Посібник

Scarlett SC-2160 Підігрівач

Посібник

Scarlett SC-FH53K04 Підігрівач

Пов'язані категорії