Посібник EMOS E8236 Метеостанція

Потрібен посібник для вашого EMOS E8236 Метеостанція? Нижче ви можете безкоштовно переглянути та завантажити посібник у форматі PDF українською мовою. Наразі цей продукт має 5 поширених запитання, 0 коментарів і 0 голосів. Якщо це не той посібник, який вам потрібен, будь ласка, зв’яжіться з нами.

Ваш товар несправний, а посібник не пропонує рішення? Перейдіть на Repair Café, щоб отримати безкоштовні послуги з ремонту.

Посібник

Loading…

3
Follow these steps:
1. Open the cover at the rear of the station and the rear of the sensor.
2. Insert 2 1.5 V batteries type AAA for the weather station and close the cover. Then insert 2 1.5 V batteries type AA into the
sensor. Make sure to observe the correct polarity of the batteries according to the drawing at the bottom of the battery
compartment!
3. Outdoor temperature will be displayed on the weather station within 2 minutes. If outdoor temperature is not displayed,
remove the batteries from the sensor and reinsert them or long-press the TX button under the battery cover of the sensor
to again send signal from the sensor to the weather station.
4. Close the sensor cover and place the sensor outside on a dry, shaded place. We recommend placing the sensor on the north
side of the house. The range of the sensor may decrease substantially in areas with large number of obstacles.
5. The sensor is resistant to dripping water; however, it should not be exposed to sustained rain.
6. Do not place the sensor on metal objects; doing so will reduce the transmission range.
Switching Over to Another Channel and Connecting Additional Sensors
(The following procedure for connecting additional sensors is for a replacement sensor E05018. It does not apply to the sensor included
in the package).
1. Select the desired sensor channel number – 1, 2 or 3 – by pressing the CH button at the rear of the weather station. Then
press and hold the CH button, the
icon will start ashing.
2. Remove the cover from the battery compartment and insert batteries (2× 1.5 V AAA).
3. Use the CH button to set the desired sensor channel number – 1, 2, 3 – which will be shown on the front panel display.
Data from the sensor will be loaded within 3 minutes.
4. If the sensor signal is not detected, remove the batteries, reinsert them and repeat the process.
Synchronisation of Lost Temperature Signal
In case the weather station is not showing data from the outdoor sensor, check:
Distance of the station or sensor from sources of interference such as computer monitors or TV sets. It should be at least
2 meters.
Whether the weather station or sensor is not in the proximity of metal objects and frames (such as window frames).
Whether the weather station functionality is not aected by other devices using a similar frequency (wireless headphones,
wireless blinds control, gate control, garage door control etc.), or wireless devices used in the immediate neighbourhood.
Maximum range of the wireless sensor is 35 m in an open area. The range depends on local conditions and the construction
materials of buildings.
Transmission is also aected by interferences in the area. If reception fails, try to restore functionality by removing the batteries.
If there is interference to radio or television reception caused by the device’s transmission, this can be removed by one of the
following measures:
Reorient or relocate the antenna
Increase the distance between the device and the receiver
Consult with your dealer or an authorized service
The inuence of ambient radio interference may result in poor data display.
Radio Controlled Clock – DCF77
The radio controlled clock provides the most accurate time on the European continent. The radio signal propagates via radio
waves (77.5 kHz) from a site near Frankfurt on the Main in Germany within a range of 1 500 km. This radio time signal automat-
ically takes into account summer (DST) and winter time, leap years and date changes. In standard conditions (at safe distance
from sources of interference, such as TV sets, computer monitors), the reception of time signal takes several minutes. If the clock
does not detect the signal, follow these steps:
1. Move the weather station to another location and try to detect the DCF signal again.
2. Make sure the distance of the clock from sources of interference, such as computer monitors or television sets, is at least
1.5 to 2 meters when receiving this signal. When receiving DCF signal, do not put the weather station in the proximity of
metal doors, window frames and other metal structures or objects (washing machines, dryers, refrigerators etc.).
3. In reinforced concrete structures (cellars, high-rise buildings etc.), the DCF signal reception is weaker, depending on the
conditions. In extreme cases, place the weather station close to a window toward the transmitter.
The reception of the DCF77 radio signal is aected by the following factors:
thick walls and insulation, basements and cellars
inadequate local geographical conditions (these are dicult to assess in advance)
atmospheric disturbances, thunderstorms
appliances with no interference elimination
television sets and computers placed near the DCF receiver
DCF Signal Reception
If the batteries in the weather station are suciently charged, DCF signal reception and time setting will occur automatically.
The weather station will begin automatically searching for DCF signal 3 minutes after the insertion of batteries. The search for
signal takes 7 minutes. The
icon will be ashing. If the station successfully detects DCF signal, the correct time and date will
be set and the
icon will remain on the screen. If the station fails to detect DCF signal, you can activate the search manually
by pressing and holding the WAVE button. If you wish to cancel the manual search mode, again press and hold the WAVE button.
Завантажити посібник українською мовою (PDF, 1.37 MB)
(Бережіть природу: роздрукуйте цей посібник лише у випадку, коли це дійсно необхідно)

Loading…

Рейтинг

Дайте нам знати, що ви думаєте про EMOS E8236 Метеостанція, залишивши рейтинг продукту. Хочете поділитися своїм досвідом щодо цього продукту або задати запитання? Будь ласка, залиште коментар внизу сторінки.
Ви задоволені EMOS E8236 Метеостанція?
Так Ні
Оцініть цей товар першим
0 голоси

Приєднуйтесь до розмови про цей продукт

Тут ви можете поділитися своєю думкою про EMOS E8236 Метеостанція. Якщо у вас є питання, спочатку уважно прочитайте інструкцію. Запит на інструкцію можна зробити за допомогою нашої контактної форми.

Детальніше про цей посібник

Ми розуміємо, що добре мати паперовий посібник для вашого EMOS E8236 Метеостанція. Ви завжди можете завантажити посібник з нашого сайту та роздрукувати самостійно. Якщо ви бажаєте отримати оригінальний посібник, радимо зв’язатися з EMOS. Вони можуть надати оригінальний посібник. Шукаєте інструкцію до свого EMOS E8236 Метеостанція іншою мовою? Виберіть потрібну мову на нашій домашній сторінці та знайдіть номер моделі, щоб дізнатися, чи є вона у нас.

Технічні характеристики

Бренд EMOS
Модель E8236
Категорія Метеостанції
Тип файлу PDF
Розмір файлу 1.37 MB

Усі посібники для EMOS Метеостанції
Більше посібників для Метеостанції

Часті запитання про EMOS E8236 Метеостанція

Наша служба підтримки шукає корисну інформацію про товар і відповідає на поширені запитання. Якщо ви знайдете неточність у наших запитаннях та відповідях, повідомте нас про це, скориставшись контактною формою.

Моя метеостанція передбачила, що піде дощ, але цього не сталося. Чому так? Підтверджено

Прогноз на метеостанції базується на тиску повітря. Загалом низький тиск означає погану погоду, а високий тиск означає хорошу погоду. Можливо, погода розвивається інакше, ніж прогнозує тиск повітря.

Це було корисно (1404) Читати далі

Яке найкраще розташування метеостанції та її датчиків? Підтверджено

Сама метеостанція розміщена всередині і її потрібно тримати подалі від джерел тепла, таких як кухня, вікна або електроприлади. Окремий датчик зовнішньої температури потрібно розміщувати в тіні та принаймні на 1,25 м над землею. Датчик дощу потрібно розміщувати на відкритому майданчику, де він завжди може збирати дощ. Датчик вітру також потрібно розміщувати на відкритому майданчику з будь-якими перешкодами, що впливають на вітер.

Це було корисно (334) Читати далі

Моя метеостанція має дощомір, чи може вона також вимірювати кількість снігопаду? Підтверджено

Деякі датчики дощу оснащені нагрівальним елементом, завдяки чому сніг тане і дозволяє вимірювати його. Без нагрівального елемента дощомір засмітиться, і вимірювання виконати неможливо.

Це було корисно (235) Читати далі

Акумулятор у моєму пристрої окислюється, чи можу я все ще безпечно ним користуватися? Підтверджено

Так, пристроєм все ще можна безпечно користуватися. Спочатку вийміть окислювальну батарею. Ніколи не використовуйте для цього голі руки. Потім очистіть батарейний відсік ватним тампоном, змоченим в оцті або лимонному соку. Дайте йому висохнути і вставте нові батареї.

Це було корисно (234) Читати далі

Чи можу я тривалий час залишати змінну батарею в пристрої? Підтверджено

Змінні акумулятори можуть тривалий час залишатися в пристрої, якщо пристрій використовується. Коли пристрій зберігається тривалий час, бажано вийняти батареї, щоб запобігти окисленню.

Це було корисно (234) Читати далі
Посібник EMOS E8236 Метеостанція

Супутні товари

Пов'язані категорії